You are viewing the site in preview mode

Skip to main content


  • Poster presentation
  • Open Access

New equipment optimized for emulsified vaccine prepation in the hospital

  • 1 and
  • 2
Journal for ImmunoTherapy of Cancer20131 (Suppl 1) :P196

  • Published:

We’re sorry, something doesn't seem to be working properly.

Please try refreshing the page. If that doesn't work, please contact support so we can address the problem.


  • Particle Size
  • Disperse Phase
  • Average Particle Size
  • Applied Process
  • Stable Formulation

Developing stable formulations is generally a common target to obtain efficacious emulsified vaccines. Process used to perform water in oil (W/O) emulsions are not all equivalent regarding vaccines physico-chemical parameters. Equipment generally used to realise emulsified vaccines can be high shear mixers, vortex, syringes, or syringes connectors. It was already reported that applied process has a direct impact on quality, stability and particles size of dispersed phase (Ascarateil, Isbtc 2008). Moreover it can influence directly biological effects of the vaccine, and especially its action against tumor (Koh, 2006). Differences of process from a clinical trial to another can be a root of misunderstanding on the results obtained, and certainly the cause of unexpected variations. In the hospital obtaining reproducible and stable W/O emulsions is a challenge for the pharmacy or the operators involved. It is important to ensure sterility while vaccine is prepared at patient’s bed. The equipment used for this preparation has thus to be disposable, developed in order to lower human errors to the max, and be not time consuming. Here we present the development of a new equipment optimized for automatic W/O emulsion process. It is a closed system allowing to maintain sterility while emulsification process is running. Process has been optimized according to already existing experiences on this kind of process. The machine is able to repeat low and fast rhythm cycle as they are performed in the hand I connector process and the operation is blocked after a determined number of cycles. Emulsions obtained were analysed for their viscosity, microscopic appearance and their particle sizes with Mastersizer™ equipment. Placebo emulsions have to present an average particle size of 1µm in order to validate the process parameters. Emulsions were put in a stability program for one month a three different temperatures with the aim that particle sizes should vary during this period. The emulsifying adjuvants used for the qualification of this new equipment were Montanide™ ISA 51 and Montanide™ ISA 720.

Authors’ Affiliations

Biologicals and Injectables, SEPPIC, Puteaux, France
Biologicals and Injectables, SEPPIC Inc, Fairfield, NJ, USA


© Ascarateil and Koziol; licensee BioMed Central Ltd. 2013

This article is published under license to BioMed Central Ltd. This is an Open Access article distributed under the terms of the Creative Commons Attribution License (, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.